Ditch Foreslope (Override)

Adhoc Name: DitchForeslope
Description: Ditch Foreslope (Override)

Typical Section showing variables

ADHOC DESCRIPTIONS

BeginSlope” - Specified in a Rise:Run format, represents the slope of the beginning location of the override element location.

IMPORTANT: The override element must never start before the beginning of the proposed baseline.

EndSlope” - Specified in a Rise:Run format, represents the slope of the ending location of the override element location.

NOTE: If no tapering is desired, set this value to equal the same value as the BeginSlope adhoc attribute.

IMPORTANT: The override element must never end past the end of the proposed baseline.

SlopeDecimalPlaces” Controls the number of decimal places shown when the slope of the line is labeled.

CADD Support  |  GEOPAK Typicals  |  Top