Ditch Foreslope Height (Override)

Adhoc Name: DitchForeslopeH
Description: Ditch Foreslope Height (Override)

Typical Section showing variables

ADHOC DESCRIPTIONS

BeginHeight” - Specified in Master Units, represents the height of the beginning location of the override element location.

IMPORTANT: The override element must never start before the beginning of the proposed baseline.

EndHeight” - Specified in Master Units, represents the height of the ending location of the override element location.

NOTE: If no tapering is desired, set this value to equal the same value as the BeginHeight adhoc attribute.

IMPORTANT: The override element must never end past the end of the proposed baseline.

CADD Support  |  GEOPAK Typicals  |  Top