Flat Bottom Ditch Width (Override)

Adhoc Name: FlatBottomDitch
Description: Flat Bottom Ditch Width (Override)

Typical Section showing variables

ADHOC DESCRIPTIONS

BeginWidth” - Specified in Master Units, represents the width of the beginning location of the override element location.

IMPORTANT: The override element must never start before the beginning of the proposed baseline.

EndWidth” - Specified in Master Units, represents the width of the ending location of the override element location.

NOTE: If no tapering is desired, set this value to equal the same value as the BeginWidth adhoc attribute.

IMPORTANT: The override element must never end past the end of the proposed baseline.

CADD Support  |  GEOPAK Typicals  |  Top