Sidewalk

Adhoc Name: Sidewalk
Description: Sidewalk

Typical Section showing variables

Typical Section showing variables

ADHOC DESCRIPTIONS

S/W Layer 1 Thickness” - Sidewalk Layer 1 thickness in master units. This first layer must be greater than zero.

S/W Layer 2 Thickness” - Sidewalk Layer 2 thickness in master units. This layer can be zero if no second layer is desired

S/W Layer 3 Thickness” - Sidewalk Layer 3 thickness in master units. This layer can be zero if no second layer is desired

S/W Layer 4 Thickness” - Sidewalk Layer 4 thickness in master units. This layer can be zero if no second layer is desired

Parkway Slope Option” - Slope in percent format between back of curb and front edge of sidewalk if specified as a number i.e. ^-6^ OR use option ^TG^ for a tie back of walk to ground option. Note this variable will not have any effect if a sidewalk profile is specified. Carets MUST be used for either option.

S/W Slope” - Cross slope of sidewalk in percent format. Do not include the percent sign.

S/W Buffer Width” - Distance in master units beyond back of sidewalk before transitioning to fill slope or ditch fore slope.

S/W Buffer Slope” - Slope in percent format to be used for the adhoc “S/W Buffer Width”. Do not include the percent sign.

S/W Profile” - List the name of an optional sidewalk profile for the sidewalk to follow when the sidewalk is NOT adjacent to the back of the type 1 or type 2 curb.

NOTE:
  • Multiple profiles are allowed, each must be separated by commas.
  • The profile will control the vertical location of the inside of the sidewalk in the event the cross section station lies within the station range of the profile.

CADD Support  |  GEOPAK Typicals  |  Top