Subexcavation (Override)

Adhoc Name: SubExcavation
Description: Subexcavation (Override)

Typical Section showing variables

ADHOC DESCRIPTIONS

BeginDepth” - Specified in master units, represents the depth of the beginning location of the override element location.

IMPORTANT: The override element must never start before the beginning of the proposed baseline.

EndDepth” - Specified in master units, represents the depth of the ending location of the override element location.

NOTE: If no tapering is desired, set this value to equal the same value as the BeginDepth adhoc attribute.

IMPORTANT: The override element must never end past the end of the proposed baseline.

SubexType” - Enter a value of 1 or 2 to specify the subexcavation type.

CADD Support  |  GEOPAK Typicals  |  Top